– Drive with the load lowered.
– Even with sideshifts, align the load as cen-
trally as possible with the truck and trans-
port in this position.
– Avoid turning and driving diagonally across
slopes or gradients.
– Never have the load facing downhill when
travelling on slopes or gradients.
– Pick up only loads of the approved width.
– Do not transport swinging loads.
– Always take great care when transporting
suspended loads.
– Do not drive over ramp edges or steps.
Special risks associated with using
the truck and attachments
DANGER
Risk of explosion!
Working within potentially explosive
areas with attachments that do not com-
ply with explosion-protection regulations
can lead to explosions in the surround-
ing atmosphere!
– Only operate attachments that comply
with the explosion-protection regula-
tions.
– Check the area of application by com-
paring with nameplate information on
the attachments.
– If the area of application is not clear,
ask a safety officer.
Approval from the manufacturer and attach-
ment manufacturer must be obtained each
time the truck is used in a manner that falls
outside the scope of normal use, and in cases
where the driver is not certain that he can use
the truck correctly and without the risk of acci-
dents.
It is essential that the safety officer gives ap-
proval before each use.
Safety
2
Residual risk
54 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
