Depressurising the hydraulic circuits for
the additional functions
The additional features include features such
as the sideshift and fork adjustment. Clamping
attachments are also connected to these hy-
draulic circuits. These functions are controlled
via hydraulic circuits three and four.
– Actuate the operating levers (3, 4) for con-
trolling the additional functions once in the
direction of the arrow until the end positions
are reached.
The hydraulic circuits of the additional func-
tions are now depressurised.
NOTE
Depending on the equipment, the operating
lever (2) can be assigned the sideshift and the
fork adjustment functions.
– In this case, press the button (1) and hold it
down.
– Push the operating lever (2) once in the di-
rection of the arrow until the end position is
reached.
– Release the button (1).
The hydraulic circuits of the sideshift and fork
adjustment are now depressurised. The plug
connectors on the lift mast are depressurised.
Completing the depressurisation
– To complete the depressurisation, observe
the section entitled "Exiting the wizard".
Depressurising the hydraulic sys-
tem using multi-lever operation and
the 5th and 6th function
If the truck is equipped with multi-lever opera-
tion, the attachments can also be controlled
via the "5th hydraulic function" and "6th hy-
draulic function".
– Start the "wizard for depressurising the hy-
draulic system".
6219_003-250
2
3
4
1
Operation
4
Depressurising the hydraulic system
28556368011531 EN - 01/2021 - 05
To Next Page
