– Select the desired drive direction.
– Press the accelerator pedal.
The truck will travel in the selected drive direc-
tion.
NOTE
The drive direction can also be changed dur-
ing travel. Your foot can remain on the accel-
erator pedal while you do so. The truck is then
decelerated and accelerated again in the op-
posite direction (reversing).
NOTE
If an electrical fault occurs in the accelerator,
the drive unit is switched off. In this situation,
the truck is not electrically braked. Once the
electrical fault has been corrected, it will be
possible to drive the truck again by releasing
the accelerator pedal and then actuating the
accelerator pedal again. If the truck still cannot
be operated, park the truck securely and con-
tact the authorised service centre.
Starting drive mode, dual pedal ver-
sion (variant)
DANGER
Being trapped under a rolling or tipping truck could
cause fatal injuries!
– Sit on the driver's seat.
– Fasten the seat belt.
– Activate the available restraint systems.
– Observe the information in the chapter enti-
tled "Safety regulations when driving".
The driver's seat is equipped with a seat
switch. This seat switch checks whether the
driver's seat is occupied. If the driver's seat is
not occupied or if the seat switch is malfunc-
tioning, the truck cannot be moved. All lifting
functions are disabled. In these situations, the
message
Sit on driver's seat
is
shown on the display of the display-operating
unit.
– Sit on the driver's seat. Fasten the seat belt.
Operation
4
Driving
200 56368011531 EN - 01/2021 - 05
To Next Page
