Transporting the lead-acid battery
by crane
DANGER
There is risk of fatal injury from being
struck by falling loads!
– Never walk or stand underneath sus-
pended loads.
The tray for the lead-acid battery (1) is equip-
ped with four lifting eyes. The battery may only
be transported by crane using a lifting gear
and bridge piece (2) that are suitable in terms
in size and load capacity.
– To avoid short circuits, cover batteries with
open terminals or connectors with a rubber
mat.
– Observe the operating instructions for the
lifting gear.
– Attach the battery (1) to suitable lifting gear
(2).
– Lift the battery carefully and ensure that it
hangs straight on the lifting gear.
The lifting gear must be vertical when lifting,
so that no lateral pressure is applied to the
tray.
– Set the battery down carefully.
– Remove the lifting gear after the battery has
been set down.
– Do not place slack lifting gear on the battery
cells or allow it to fall on the battery cells.
6210_003-012
1
2
Operation
4
Replacing and transporting the battery
424 56368011531 EN - 01/2021 - 05
To Next Page
