work and adjustment work that cannot be per-
formed by the operating company. See also
the chapter entitled "Definition of responsible
persons".
– To commission the truck, contact the au-
thorised service centre.
Proper use
The truck described in these operating instruc-
tions is suitable for lifting, transporting and
stacking loads.
The truck may only be used for its proper pur-
pose as set out and described in these operat-
ing instructions.
The industrial truck may only be used in the
areas at risk of explosion for which it is ap-
proved in accordance with the attached EC
declaration of conformity and type approval.
NOTE
For explanations of the various areas, see the
chapter entitled "Basic information on explo-
sion protection"
If the truck is to be used for purposes other
than those specified in the operating instruc-
tions, the approval of the manufacturer and, if
applicable, the relevant regulatory authorities
must be obtained beforehand in order to pre-
vent hazards.
The maximum load to be lifted is specified on
the capacity rating plate (load diagram) and
must not be exceeded; see also the chapter
entitled "Before picking up a load"
Foreword
1
Using the truck
2356368011531 EN - 01/2021 - 05
To Next Page
Loading...
