– If the load programs are saved as a favour-
ite on a softkey, press the "Load dynam-
ics"
softkey until the number of the de-
sired load program is shown on the display.
The number of dynamic bar segments shows
the load dynamics of the selected load pro-
gram.
NOTE
During the warm-up phase, the load dynamics
are limited to
load program 1.
Fork wear protection (variant)
The "fork wear protection" variant ensures that
the fork arms do not touch the ground. The
fork arms are protected against wear and the
building floor is protected against damage.
The lift cylinders have in-built fixed stops to
prevent the fork arms from hitting the ground.
The lower stop makes inserting the forks into
a pallet more comfortable.
The driver cannot adjust the fork wear protec-
tion manually. However, the fork wear protec-
tion must be continually adjusted as the wear
on the front tyres increases.
– Contact the authorised service centre on
this matter.
Operation
4
Lifting
246 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
