– Turn the battery isolation switch (1) anti-
clockwise up to the stop and into the "OFF"
position.
NOTE
Switch keys, FleetManager cards (variant),
FleetManager transponder chips (variant) and
the PIN code for access authorisation (variant)
must not be handed over to other persons un-
less explicit instructions to this effect have
been given by the responsible fleet manager.
Wheel chock (variant)
The wheel chock (variant) is used to prevent
the truck from rolling away on a slope. It is lo-
cated on the right-hand mudguard.
– Pull the latch forward (1) and hold it in
place.
– Grip the wheel chock by its handle (3). Re-
move the wheel chock from the support
mounting via the guide (2).
– Push the wheel chock under a front axle
wheel on the side facing the descending
gradient.
– After use, reinsert the wheel chock in the
support mounting.
– Make sure that it is correctly seated in the
guide (2) and that the latch (1) is holding
the wheel chock in place.
1
6219_901-006
6219_003-145
1
2
3
Operation
4
Parking
228 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
