WARNING
Risk of accident as a result of exceeding the residual
load capacity.
If the weight determined by a load measurement ex-
ceeds the permissible residual load capacity of the
truck, the truck cannot be operated safely.
– Set down and reduce the load immediately.
– If necessary, use another truck with sufficient
load-bearing capacity.
NOTE
The load measurement must be calibrated in
order to ensure accuracy at all times. The "ac-
cess authorisation for the fleet manager" is re-
quired for the calibration. This access is re-
quired:
●
After changing the fork arms,
●
After fitting or changing attachments
●
If the displayed values are obviously incor-
rect
If
-.-- t
is displayed permanently, this
means that the function is calibrated incorrect-
ly (load < 0 kg).
– See the section entitled "Calibrating the
load measurement".
Calibrating the load measurement
If the truck is equipped with the "load meas-
urement" assistance system, then this assis-
tance system must be calibrated.
The load measurement is calibrated using a
wizard on the display-operating unit.
NOTE
The calibration procedure requires access au-
thorisation for the fleet manager. Access to
the settings menu is only available if the truck
is at a standstill and the parking brake is ap-
plied. If the parking brake is released prema-
turely, the settings menu will close.
– Set the load down, if necessary.
– Drive the truck onto an even surface.
Operation
4
Load-dependant assistance systems
17356368011531 EN - 01/2021 - 05
To Next Page
Loading...
