Procedure in emergencies
Emergency shutdown
WARNING
No electric braking assistance is available if the
emergency off switch or the battery isolating switch
has been actuated.
Actuating the emergency off switch (1) disconnects
the drives from the power supply. Actuating the bat-
tery isolating switch (2) disconnects the entire truck
from the power supply.
The truck will not be held on a slope by the regenera-
tive brake.
– To brake, actuate the service brake.
CAUTION
Potential for damage to the battery male connector!
If the battery male connector is disconnected while
the truck is switched on (under load), an arc will be
produced. This can lead to erosion at the contacts,
which considerably shortens the service life of the
contacts.
– Switch off the truck before the battery male con-
nector is disconnected.
– Do not disconnect the battery male connector
while the truck is switched on, except in an emer-
gency.
In an emergency, all functions of the truck can
be shut down:
– Press the emergency off switch (1) or turn
the battery isolating switch (2) to "OFF".
In drive mode, pressing the emergency off
switch (1) or turning the battery isolating
switch (2) has the following effects:
●
No reduction in truck speed when the accel-
erator pedal is released, according to the
drive programme selected. The truck will
coast to a stop.
●
The electric brake does not function during
the first part of brake pedal travel:
To decelerate the truck with the mechanical
brake, the brake pedal has to be pressed
down further.
●
The truck can only be held on a slope using
the mechanical brake, not the electric
brake.
2
6219_901-014
Operation
4
Procedure in emergencies
37556368011531 EN - 01/2021 - 05
To Next Page
Loading...
