– Never drive with a load protruding to the
side (e.g. with the sideshift)!
Shake function (variant)
NOTE
The shake function is intended only for short-
term use, as it reduces the service life of the
load chains due to the increased loading on
them.
Description
The shake function of the hydraulics makes it
easier for the driver to perform tasks such as
emptying containers of bulk material. The
shake function moves the fork carriage quickly
up and down via the "Lifting" function.
This function may only be used for a limited
load and must not be used with a full nominal
load.
Maximum permissible load for the shake
function:
●
Maximum 30% of the nominal load. If an at-
tachment is being used, its weight must be
subtracted from this value.
NOTE
The weight of an attachment can be seen on
its nameplate.
Operation
4
Handling loads
272 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
