Operation
To activate the shake function:
– Move the corresponding operating device
for the "Lifting" function over the zero posi-
tion four times in quick succession.
The fork carriage moves as normal. The
shake function is active after the fourth time
the operating device is moved.
– Continue to move the operating device back
and forth.
The fork carriage moves up and down more
quickly and more jerkily.
The intensity of the shaking is controlled via
the vigour with which the operating device is
moved. The more vigorously and frequently
the operating device is moved, the more in-
tense the shaking is.
NOTE
After the function has been activated, the driv-
er has two seconds to start the shaking. If the
two seconds elapse without the shake function
being used, the shake function is deactivated
again.
WARNING
The shake function remains active for two seconds
following activation.
If the driver simply wants to lift or lower the load dur-
ing this time, note that the fork carriage may move
significantly more jerkily with the load than in normal
operation. If the two seconds elapse without the
shake function being used, the fork carriage can be
moved normally again with the load.
The following section shows how the shake
function is activated via the standard assign-
ment for "lifting/lowering" using the different
variants of the operating devices. If the "lifting/
lowering" function is assigned differently on
the operating device, the shake function is ac-
tivated via this other assignment.
Operation
4
Handling loads
27356368011531 EN - 01/2021 - 05
To Next Page
Loading...
