Controlling attachments using the
double mini-lever and the 5th func-
tion
NOTE
For technical reasons, clamping attachments
must not
be controlled via the "5th function".
The function key for the "5th function" (3) and
the cross lever (1) are used to control the
"5th function".
The adhesive label bearing the pictograms for
the hydraulic functions (2) is affixed at the
designated point.
– If the adhesive label becomes illegible or is
missing, please contact your authorised
service centre.
– Observe the pictograms for the attachment
functions on the adhesive label (2).
The pictograms on the "attachments" cross
lever show the respective functions that are
activated by this lever.
The following applies:
– Actuate the function key for the "5th func-
tion" (3).
The LED for the "5th function"
lights up.
– Move the "attachments" cross lever (1) in
the direction of the arrow (A), (B), (C) or
(D).
The attachment moves accordingly in the di-
rections (A), (B), (C) or (D) as shown in the
pictogram.
Operation
4
Attachments
31556368011531 EN - 01/2021 - 05
To Next Page
Loading...
