Replacing and transporting the battery
General information on replacing
the battery
DANGER
Risk of explosion!
Working on a truck within potentially ex-
plosive areas can lead to explosions in
the surrounding atmosphere.
No work must be performed on the truck
in potentially explosive areas!
– Only connect or disconnect battery
male connectors outside of potentially
explosive areas.
– Only change batteries outside of po-
tentially explosive areas.
CAUTION
Risk of components being damaged by the lifting ac-
cessory and battery rolling away!
If the battery is not on a level, smooth floor with suffi-
cient load-bearing capacity, lifting accessories and
the battery can roll away in an uncontrolled manner.
– Follow the operating instructions for the lifting ac-
cessories used.
– Always remove the battery on a level, smooth
floor with sufficient load capacity.
Batteries can be removed with a truck and
with a lift truck equipped with a battery change
frame.
The load capacity of the lifting accessory used
must at least match the battery weight. See
the battery nameplate.
NOTE
Depending on the version, a potential equali-
sation connection is present between the bat-
tery tray and truck. When removing the bat-
tery, this connection must be disconnected at
the potential equalisation point. The potential
equalisation point is identified by the decal in-
formation
.
Operation
4
Replacing and transporting the battery
40756368011531 EN - 01/2021 - 05
To Next Page
Loading...
