Cab
Opening and closing the cab door
DANGER
Risk of explosion due to static charge!
The plastic parts on category 2 trucks
are coated with a special antistatic paint.
This paint prevents the build-up of an
electrostatic charge in plastic compo-
nents. Otherwise, static discharge may
occur, resulting in explosions in the sur-
rounding atmosphere in potentially ex-
plosive areas.
The plastic parts of the cab (variant) are
also covered with antistatic materials or
coated with antistatic paint.
– Only drive into potentially explosive
areas if the cab or fabric-covered cab
complies with explosion protection di-
rectives.
– Make sure that the surfaces are not
damaged.
CAUTION
Risk of component damage.
If the cab door opens while driving, there is risk of
damage from a collision.
– The cab door must be latched securely in the en-
gaged position.
The truck has a cab door sensor that is used
to monitor the closing of the cab door.
If the seat belt is not fastened and the cab
door is not closed, the driving speed is limited
to 4 km/h. The message
Close cab door
or seat belt
appears in the display.
If the cab door is opened while the truck is in
motion and the seat belt is fastened, the truck
decelerates and is restricted to a driving
speed of 4 km/h. The message
Close cab
door
appears in the display.
If the seat belt is released with the cab door
closed, no message appears.
Opening the cab door from the outside:
– Insert the key in the door lock (5), unlock
the door and remove the key.
6219_003-132
5
4
3
21
Operation
4
Cab
342 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
