Releasing the seat belt
– Push the red button (4) on the buckle (1).
– Slowly guide the belt tongue back to the re-
tractor by hand.
NOTE
Slowly allow the seat belt to retract. The auto-
matic blocking mechanism may be triggered if
the belt tongue strikes the housing. It will then
no longer be possible to pull the seat belt out
with the usual force.
– Using increased force, pull the seat belt
around 10 to 15 mm out of the retractor to
disengage the blocking mechanism.
– Slowly allow the seat belt to retract again.
– Protect the seat belt from dirt, for example,
by covering it.
Malfunction due to cold
– If the buckle or belt retractor are frozen,
thaw the buckle or the belt retractor and dry
the parts.
This prevents the parts from refreezing.
CAUTION
The seat belt may be damaged by heat!
Do not subject the buckle or belt retractor to exces-
sive heat when thawing.
– Do not use air warmer than 60°C when thawing.
7090_342-005
1
4
Operation
4
Driver's seat
11756368011531 EN - 01/2021 - 05
To Next Page
