Legend for model
C Compact
LLong
PSwing axle version
The ascending and descending gradients
must not exceed the gradients listed above
and must have a rough surface.
The top and bottom of the gradient must fea-
ture smooth and gradual transitions to prevent
the load from falling to the ground or the truck
being damaged.
Warning in the event that components
protrude beyond the truck contour
Trucks are often required to drive through very
narrow or very low spaces such as aisles or
containers. The dimensions of the trucks are
designed for this purpose. However, movable
components may protrude beyond the truck
contour and be damaged or torn off. Examples
of these components are:
●
An unfolded roof panel in the driver's cab
●
Open cab doors
Condition of the roadways
Roadways must be sufficiently firm and even.
The surface must be free from contamination
and fallen objects.
Drainage channels, level crossings and similar
obstacles must be evened out and, if necessa-
ry, ramps must be provided so that trucks can
drive over these obstacles with as few bumps
as possible.
Take note of the load capacity of manhole
covers, drain covers etc.
There must be sufficient distance between the
highest points of the truck or the load and the
fixed elements of the surrounding area. The
height is based on the overall height of the lift
mast and the dimensions of the load; see the
chapter entitled "Technical data".
Operation
4
Driving
19156368011531 EN - 01/2021 - 05
To Next Page
