Picto-
gram
Attachment function
Tip shovel over
Tip shovel back
NOTE
The pictograms are affixed according to the
attachment fitted at the factory. If an attach-
ment with different functions is fitted, the au-
thorised service centre must check that the
pictograms bear the correct representation
and must change them if necessary.
Clamp locking mechanism
– To release the clamp locking mechanism,
push the operating lever (2) forwards.
The clamp locking mechanism is released.
The LED for the "clamp release" (1) lights up
and remains lit while the clamp locking mech-
anism is released.
NOTE
The hydraulic function for opening the clamp
is available for one second after the clamp
locking mechanism is released. After one sec-
ond, the clamp locking mechanism is automat-
ically reactivated.
– To open the clamp, push the operating lev-
er (2) forwards again.
It is not necessary to release the clamp lock-
ing mechanism in order to close the clamp.
– To close the clamp, pull the operating lev-
er (2) backwards.
Operation
4
Attachments
322 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
