Stratasys Objet260 Connex - Page 190

Operating & Maintaining the Objet1000 Plus 3D Printer
6–68 DOC-06810 Rev. A
Thewizardoperatesthelampsandchecksiftheirpoweriswithinthe
acceptablerangeforeachprintingmode.(Themodecurrentlybeing
checkedappearsinthelower‐leftcorneroftheprinterinterface.)
Figure 6-111: Status screen during UV lamp check
14. AfterreplacingaUVlamp,itisrecommendedthatyoucalibrateits
powerforthevariousprintingmodes.Thenextscreenallowsyouto
continuetotheUVCalibrationwizard(see“TestingandCalibrating
theUVLamps”onpage 55).
Figure 6-112: Final wizard screen