TechnipFMC Sening MultiFlow - Page 129

Sening
®
is a registered trademark of FMC Technologies
135
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
consisting of several products are processed individually. A separate
receipt is produced for each product.
 If the OBC summary is activated, all products are combined on one
receipt. The maximum number of products per receipt is defined in this
case via parameter 3.1.5.2 ("Number of deliveries").
9.3.1.5 W & M Restrictions
No.
Name
Seal
K
Factory
Settings
Meaning
3.1.5
W & M Restriction
3.1.5.1
Parameter List 1
3.1.5.1.1
Volume Resolution
Cal.
1
0
Volume division: Number of post-decimal places on
volume display.
3.1.5.1.2
No. of Discharges
Cal.
1
1
Maximum number of discharges per receipt.
3.1.5.1.3
Minimum Preset
Cal.
1
200
(liters)
Minimum default volume for discharge
(in increments of 200 liters)
3.1.5.1.4
Minimum Layout
Cal.
1
2,3,(11:12),2
5
Minimum requirement from W&M for bill / delivery
receipt
3.1.5.1.5
Price Correction
Cal.
1
1 (yes)
Determines whether the retrospective modification of
prices is permitted with measured products.
3.1.5.1.6
Decimal Separator
Cal.
1
1 (‘,’)
Separator for decimal places: '.' or ','
3.1.5.1.7
Show Additive
Cal.
1
0 (no)
IMPORTANT: Parameter not currently active. See
parameter 3.3.3.3.
3.1.5.1.8
Flushing volume
3.1.5.1.8.1
Flushing product
Mast
er
3
Product index
Definition of product used to flush the measuring
system.
3.1.5.1.8.2
Flushing volume
Mast
er
3
0 (liters)
Specification of the quantity of product used to flush
the measuring system
3.1.5.1.8.3
Min. flushing volume
Cal.
1
0 (liters)
Minimum pre-set quantity after a product change (due
to product contamination) in liters. Specify according
to calibration regulations.
3.1.5.1.8.4
OBC flushing monitor
Mast
er
3
0 (no)
Monitors flushing of measuring system when
processing deliveries which have been transferred via
OBC.
0: No
1: Yes
2: Automatic
3.1.5.1.9
Force Delivery Stop
Cal.
1
0 (inactive)
Determines the time after which a delivery is
automatically terminated when no flow is recognized.
Function inactive
1-99 Time limit in minutes
3.1.5.1.0
Hide delivery
Cal.
1
0 (inactive)
When active, actual delivery quantity is not displayed
during delivery.
3.1.5.2
Parameter List 2
3.1.5.2.1
Access density
Calibr
ation
super
-visor
Drive
r
1
0
Defines parameter protection for product density
0: Seal
1: Supervisor
2: Driver
9.3.1.5.1 Access density
 The protection level for access to the density parameters in product
definition (3.5.x.x.7.4) can be specified via parameter 3.1.5.2.1. The
protection level for parameter 3.5.2.1 then automatically follows the