settings for the density parameters. There is a choice of “Seal”,
“Supervisor” or “Driver”. When “seal” is selected, the electronic seal has
to be broken to change product density. “Supervisor” means that at least
the supervisor’s password is required to change the product density. If
the seal and supervisor password protection is waived, the parameter
has to be set to “Driver”. The standard setting is “seal”. This means that
the density parameters and parameter 3.1.5.2.1 by default can only be
modified if the electronic seal is broken.
When the seal protection is activated for the density parameter, stock
monitoring can be called up in the start menu via key <F2>. In order to
facilitate quick access to the density parameter for product definition,
when the supervisor or driver protection level is activated, the function of
key <F2> in the start screen is changed as soon as the density parameter
is no longer under seal protection. The product register can now be called
up directly from the start screen via <F2>. This refers directly back to the
relevant product-specific density parameters.
Stock monitoring is accessed via menu item 2 when the seal protection
for the density parameter is deactivated.
Start screen
To Next Page
Loading...
