The text "Receipt Title" in above mask serves as a placeholder for the
receipt title, the ID of which is '20'. You define the print position on the
receipt by entering line and column.
Add a new receipt definition with <F1> "NEW".
The default setting is ID 1 "string of characters".
•
From the summary of text elements (modules) (see chapter 10.1.3 "
Summary of Text Modules " / page 200) you can now choose a pre-
defined text module (form element), or you can enter the required text
to the form display.
Press the <Enter> key to start processing the text element.
☺ With the blinking cursor you are asked to enter the "ID".
Enter the ID of the required text element and press <Enter>.
☺ Now definition of the "Line" is required.
Enter the required line position at which the text is to be printed.
•
Enter the "Column".
☺ Now the positioning of the text on the receipt is completed.
With "Attributes" and "Options" you can define the form and possible
options for the printout.
10.1.2.2
Form modification After Sealing
After the MultiFlow has been sealed the parts of the form description
relevant for calibration are secured against manipulation. This means that
those form elements listed in the minimum requirements (parameter
3.1.5.4) are specially monitored.
•
The MultiFlow prevents the formatting or the options for these elements
from being changed. The position and attributes of these elements
however remain variable.
See chapter 10 "Form Description" / page 195.
To Next Page
Loading...
