TechnipFMC Sening MultiFlow - Page 37

Sening
®
is a registered trademark of FMC Technologies
43
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  General User Instructions
identification. The test can be terminated by pressing the <Enter> key
twice.
 <Contrast>:
The range of values for the contrast of the display lies between (0…100)
and is modified with <F1> for "light", <F2> for "dark" and <F3> for "end"
and adoption of the newly-set value (default value about: „30“).
 <Handshake>:
The handshake setting (ON / OFF) for the CAN bus is modified with <F1>
for "on", <F2> for "off" and <F3> for "end" and adoption of the newly-set
value (default value: “ON”).
 <Beeper>:
The beeper can be set to (ON / OFF) with <F1> for "on", <F2> for "off"
and <F3> for "end" and adoption of the newly-set value (default value:
“ON”).
SETUP / 2 - Menu
 <F3 for „more“>:
Settings for the second set up
page.
 <Char table>:
Setting of the character sets (PC437, PC852, PC866) with <F1> for
"plus", <F2> for "minus" and <F3> for "end" and adoption of the newly-set
value (default value: “PC437”). Please also See chapter 16 "Character
sets available for the MultiFlow" / page 287 for further information.
 <F3 for „back“>:
Settings for the first setup page.
 <End>:
Leaving the SETUP DISPLAY menu.
F M C F. A. SE NI NG
SET UP D IS PL AY
T10 0V 2. 31
Cha r
ta bl e. .. :
PC4 37
up
d ow n
mo re