TechnipFMC Sening MultiFlow - Page 61

Sening
®
is a registered trademark of FMC Technologies
67
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Initial Operation
SGN
Meaning
NCN
Overfill sensor not connected
HEA
Overfill sensor heated
CHK
Overfill sensor checked
REL
Overfill sensor released
SHR
Overfill sensor short circuit
COV
Overfill sensor covered, tank full
CST
Overfill sensor disconnected, no connection to the unit
DeadMan+
Dead man’s switch released
DeadMan-
Dead man’s switch blocking, i.e. time has run out or no
connection
STS
Meaning
LNK
Connection to base station established
NOLNK
Connection to base station could not be established,
possibly blocked by a different device
5.7.5 EPE2
 The following description is relevant only for program versions 5.00and
higher (approval according to MID).
 The connection to the EPE2 is interrupted during the data transfer
between the MultiFlow and the chip card and is automatically restored at
the end.
The EPE2 diagnostic functions are compiled in menu 4.3.6.
Menu 4.3.6 EPE2
Control options →
Current status →
EPE 2
1 2 3
Li nk Ou tp ut Lin k
ON c ha ng e O FF
Li nk O ut pu t Inp ut
1 0 H
T es ti ng
Lin k S ta rt Di sco n.