Saving and recalling information
Use these procedures to save or recall waveforms, setups, or sessions.
Save a screen image
Use this procedure to save a screen image.
1. Tap the File menu and select Save As.
The Save As configuration menu opens.
2. Tap Screen Capture to open the Screen Capture tab.
3. Tap Save Location or Browse to select the location to save the file.
a. Tap the drop down arrow in the Save Location field and select the location to save the file from a list of recent save locations. Or
double-tap the field and use the virtual keyboard to enter a path to the save location.
b. Tap Browse to open the Browse Save As Location configuration menu to navigate to and select a location at which to save the file.
4. File Name shows the name last used to save a file. The default name is Tek000. To change the file name, double-tap the file name and
enter a new file name using the virtual keyboard.
5. Tap Auto Increment File Name to enable or disable automatic incrementing of a file name. Auto Increment File Name lets you save
sequential files without needing to manually rename them each time. The count number is added to the end of the file name.
• If Auto Increment File Name is enabled the Count defaults to 000 if there are no files at the specified location and file name that
already use incremented file names. If there are files at the save location that already use the specified file name, and have already
been saved using count increments, the Count field shows the next count value that will be added to the file name when the file is
saved.
• To change the starting count value, tap the Count field and use the assigned knob to change the value, or double-tap the field and
use the virtual keypad to change the value.
6. Tap Save As Type and select the desired graphic image file type from the list.
7. Tap Save to save the screen image to the specified file name, location, and type.
Save a waveform to a file
Use this procedure to save channel waveform data to a comma-separated values (csv) or Tektronix waveform data (wfm) file, for later
analysis or inclusion in reports.
1. Tap the File menu and select Save As.
The Save As configuration menu opens.
2. Tap Waveform to open the Waveform tab.
3. T
ap Save Location or Browse to select the location to save the file.
a. Tap the Save Location drop down arrow and select the location to save the file from a list of recent save locations. Or double-tap
the field and use the virtual keyboard to enter a path to the save location.
Saving and recalling information
100
To Next Page
Loading...
