LIN serial bus search configuration menu
Use the LIN Search configuration menu to define conditions to search for and mark on an LIN bus waveform. Y
ou can have multiple
searches on the same bus.
Field or control Description
Display Enables or disables displaying search marks on this search.
Act on Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page
105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Search Type Set to Bus.
Source Select the LIN bus that you want to search.
Mark On Select the type of information for which to search.
Identifier Sets the identifier pattern for which to search.
Tap the Binary, Hex, or Decimal field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available only when Mark On is Identifier or Identifier & Data.
Mark When Sets the mark when condition.
When set to Inside Range or Outside Range, fields are displayed to set a Data Low and Data High
boundary pattern for the specified search range.
Available only when Mark On is Data or Identifier & Data.
Data Sets the data pattern for which to search. The number of bits shown depends on the Data Bytes
setting.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available only when Mark On is Data or Identifier & Data.
Data Bytes Sets the number of data bytes for which to search (one to four bytes). Use the A knob to change the
value.
Available only when Mark On is Data or Identifier & Data.
Error Type Sets the error type for which to search. Tap the arrow and select the error condition.
Available when Mark On is Error.
A, B knob controls Use the A knob to select (highlight) the digit(s) to change.
Use the B knob to change the value of the digit(s).
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
See also
Bus T
rigger configuration on page 220
Menus and dialog boxes
148
To Next Page
Loading...
