Tektronix MSO 2 Series - CAN Serial Bus Search Configuration Menu (When Using a.Dbc Symbol Definition File)

Field or control Description
Data Sets the data pattern for which to search. The number of bits shown depends on the Data Bytes
setting.
T
ap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available only when Mark On is Data or ID & Data.
Error Type Sets the error type for which to search and mark on the bus waveform. (Missing Ack, Bit Stuffing, or
Any Error.
Available only when Mark On is Error.
A, B knob controls Use the A knob to select (highlight) the digit to change.
Use the B knob to change the value of the digit.
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
See also
Bus T
rigger configuration on page 220
Bus Search configuration menus on page 139
CAN serial bus configuration menu on page 133
CAN serial bus search configuration menu (when using a .dbc symbol definition file)
Use the CAN Search configuration menu to define conditions to search for and mark on an CAN bus waveform. This menu supports
searches for CAN bus events based on labels derived from a loaded .dbc symbol definition file.
Field or control Description
Display Enables or disables displaying waveform search marks for this search.
Act on Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page
105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Search Type Set to Bus.
Source Select the CAN bus that you want to search and mark.
Mark On Sets the type of information for which to search and mark on the bus waveform acquisition.
Available mark on options are Start of Frame, Types of Frame, FD Bits, Identifiers, Data, Id & Data, XL
Bits, End of Frame, Error and Symbolic.
Table continued…
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 145