I/O (Utility menu)
Use this configuration menu to set up a LAN, USB Device Port, Socket Server
, and AUX OUT signal parameters.
To open the I/O menu:
1. Tap the Utility menu.
2. Tap I/O....
Entering and applying LAN network changes
When first opening the I/O menu LAN panel, the Network Address is set to Auto (default setting) and the Apply Changes button is grayed
out (inactive) in the LAN panel.
When you select any editable input box and start entering data, the Apply Changes button becomes active, and the characters being
entered are bolded and italicized. Bold italicized text means that the values have not been applied to the oscilloscope settings.
When you tap the Apply Changes button, all changes are saved (takes about 10 seconds), the text is changed to normal font (nonbold,
nonitalic), and the Apply Changes button becomes inactive.
If you tap outside the I/O menu before you tap the Apply Changes button, the menu closes and none of your changes are saved.
LAN panel fields and controls
Field or control Description
LAN Status A readout that indicates the status of the LAN connection, either a Green circle with the word Normal
or a Red circle with an error message.
Host Name The instrument host name is displayed. To change the name, double-tap and enter a name in the
virtual keyboard.
Network Address Tap to select Manual or Automatic mode. In Automatic mode, the current Instrument IP Address,
Gateway IP Address, Subnet Mask, and DNS IP Address are displayed.
Domain Name The instrument domain name is displayed. To change the name, double-tap and enter a name in the
virtual keyboard.
Instrument IP Address Tap and use the multipurpose knobs to enter the address. Use the A knob to select the digit, and the B
knob to change the value.
A
vailable to edit when Network Address is Manual.
Subnet Mask Tap and use the multipurpose knobs to enter the mask. Use the A knob to select the digit, and the B
knob to change the value.
Available to edit when Network Address is Manual.
Service Name The instrument service name is displayed. To change the name, double-tap and enter a name in the
virtual keyboard.
Gateway IP Address Tap and use the multipurpose knobs to enter the address. Use the A knob to select the digit, and the B
knob to change the value.
Available to edit when Network Address is Manual.
DNS IP Address Tap and use the multipurpose knobs to enter the address. Use the A knob to select the digit, and the B
knob to change the value.
Available to edit when Network Address is Manual.
MAC Address A readout of the instrument MAC Address. This field is not editable.
Table continued…
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 193
To Next Page
Loading...
