Field or control Description
Addressing Mode Sets the slave device address length (7 bits or 10 bits long).
A
vailable when Mark On is Address or Address & Data.
Address Sets the address pattern for which to search. The number of bits shown depends on the Address
Mode setting.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Address or Address & Data.
Data Bytes Sets the number of data bytes for which to search (one to five bytes). Use the A knob to change the
value.
Available when Mark On is Data or Address & Data.
Data Sets the data pattern for which to search. The number of bits shown depends on the Data Bytes
setting.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Data or Address & Data.
A, B knob controls Use the A knob to select (highlight) the character to change.
Use the B knob to change the value of the character.
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
See also
Bus T
rigger configuration on page 220
Bus Search configuration menus on page 139
I2C serial bus configuration menu on page 129
SPI serial bus search configuration menu
Use the SPI Search configuration menu to define conditions to search for and mark on an SPI bus waveform. You can have multiple
searches on the same bus.
Field or control Description
Display Enables or disables displaying search marks on this search.
Act on Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page
105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Search Type Set to Bus.
Table continued…
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 141
To Next Page
Loading...
