Rechargeable battery installation
The battery pack has 2 battery slots and supports hot swapping of the batteries during operation to extend the battery run time. The
batteries are charged when the instrument is connected to an AC power source or charge each battery separately using the T
ektronix
external battery charger (TEKCHG-XX).
Procedure
1. Use your fingers to push on the battery door latch and open the door upward.
The battery door is made to easily detach from the hinges. The battery pack will still operate with the door open or removed.
2. Use the triangle alignment keys on top of the battery and battery pack slot to place the rechargeable battery into slot one or two.
The pull tab will be on the opposite side of the alignment key
. A latch secures the battery in place when inserted into the battery pack.
3. Close and latch the battery pack door.
Installing your instrument
22
To Next Page
Loading...
