Setup and Hold Trigger - Define Inputs configuration menu
Use this menu to set the input signals and their threshold levels for the Setup & Hold trigger
.
To open the Setup & Hold Trigger - Define Inputs dialog:
1. Double-tap the Trigger Badge.
2. Set the Trigger Type to Setup & Hold.
3. Tap the Data Sources Define Inputs button.
Setup & Hold Trigger - Define Inputs configuration menu fields and controls
Field or control Description
Ch(x) (analog channels) or
D(x) (digital Channels
Use to select the signal sources to test for the setup and hold condition. Tap to select for each input
source.
If a channel is a digital channel, tap the + symbol to open the list of digital inputs (D15-D8) or
(D7-D0)from which to select individual digital signals.
Use the Threshold field to set the signal level that must be exceeded for that signal to be true.
Set All Sets all signal sources to be included or not included.
Rise/Fall Time Trigger configuration menu
Use the Rise/Fall T
ime trigger to trigger when the rise or fall time of a signal is less than, greater than, equal to, or not equal to a specified
time limit.
To open the Rise/Fall Time trigger configuration menu:
1. Double-tap the Trigger badge on the Settings bar.
2. Set the Trigger Type to Rise/Fall Time.
Settings panel (Rise/Fall Time Trigger configuration menu) fields and controls
Field or control Description
Source Lists the source channel or waveform to use to trigger or search.
Trigger When
• < Limit: A signal has a rise/fall time less than the specified time limit.
• > Limit: A signal has a rise/fall time greater than the specified time limit.
• = Limit: A signal has a rise/fall time that is equal to the specified time limit (±5%).
• ≠ Limit: A signal has a rise/fall time that does not equal (is greater than or less than) the specified
time limit (±5%).
Time Limit Sets the time period condition to be met.
Slope Sets the signal transition direction to detect. (rising, falling, or either direction).
Upper Threshold
Sets the upper amplitude level through which the signal must pass to be considered a valid transition.
Lower Threshold
Sets the lower amplitude level through which the signal must pass to be considered a valid transition.
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 219
To Next Page
Loading...
