Runt Search configuration menu on page
157
Setup and Hold Search configuration menu on page 158
Timeout Search configuration menu on page 160
Rise/Fall Time Search configuration menu
Use the Rise/Fall Time search to mark occurrences where the rise or fall time is less than, greater than, equal to, or not equal to a
specified time limit.
To create a new rise/fall time search:
1. Tap Search.
2. Set the Search Type to Rise/Fall Time.
3. Select the search Source.
4. Use the menu fields to set the search parameters.
To change the settings on an existing search, double-tap the search badge and make necessary changes.
Rise/Fall Time Search configuration menu fields and controls
Field or control Description
Display Sets the display of the mark icons to either On or Off. If you have multiple searches defined, the
control turns of
f just the marks for the selected search.
Act On Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page 105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Stop Acquisition if Event
Found
Stops input acquisition when the search event occurs. Default is not enabled.
Search Type Set to Rise/Fall Time.
Source Lists the source channel or waveform to use to trigger or search. Types that require multiple inputs will
replace this control with a different source definition control.
Mark When
• < Limit: A signal has a rise/fall time less than the specified time limit.
• > Limit: A signal has a rise/fall time greater than the specified time limit.
• = Limit: A signal has a rise/fall time that is equal to the specified time limit (±5%).
• ≠ Limit: A signal has a rise/fall time that does not equal (is greater than or less than) the specified
time limit (±5%).
Time Limit Sets the time period condition to be met.
Slope Sets the signal transition direction to detect. (rising, falling, or either direction).
Upper Threshold
Sets the upper amplitude level through which the signal must pass to be considered a valid transition.
Lower Threshold
Sets the lower amplitude level through which the signal must pass to be considered a valid transition.
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
Menus and dialog boxes
156
To Next Page
Loading...
