3. Select the search Source.
4. Use the menu fields to set the search parameters.
T
o change the settings on an existing search, double-tap the search badge and make necessary changes.
Edge Search configuration menu fields and controls
Field or control Description
Display Sets the display of the mark icons to either On or Off. If you have multiple searches defined, the
control turns of
f just the marks for the selected search.
Act On Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page 105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Stop Acquisition if Event
Found
Stops input acquisition when the search event occurs. Default is not enabled.
Search Type Set to Edge.
Source Lists the source channel or waveform to use to trigger or search. Types that require multiple inputs will
replace this control with a different source definition control.
Level Sets the amplitude level that the signal must pass through to be considered a valid transition.
Set to 50% Sets the threshold at 50% of the measured signal transition range. 50% is calculated as (Top +
Bottom)/2.
Slope Sets the signal transition direction to detect. (rising, falling, or either direction).
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
Other search types
Bus Search configuration menus on page 139
Logic search configuration menu on page
152
Pulse Width Search configuration menu on page 154
Rise/Fall Time Search configuration menu on page 156
Runt Search configuration menu on page 157
Setup and Hold Search configuration menu on page 158
Timeout Search configuration menu on page 160
Logic search configuration menu
Use the Logic search to mark when specified logic conditions occur on an analog, digital, math, or reference waveform.
To create a new logic search:
1. Tap Search.
2. Set the Search Type to Logic.
Menus and dialog boxes
152
To Next Page
Loading...
