Field or control Description
Browse Tap to open the Browse Save As Location dialog, to navigate to and select the location to save the file.
See Browse Save As Location configuration menu on page 184.
File Name Enter the file name. The default file name is Tek000. The file name increments on the next save
(T
ek001, Tek002, and so on).
Double-tap on the file name to open the virtual keyboard or use an external keyboard to enter the
name.
Save as Type You can only save a Custom Results Table to a comma-separated value (CSV) file.
Measurement Table configuration menu
Use this menu to select which statistics to show in the Measurement Results table, select the number of digits to show in each column,
save a table, and so on.
T
o open the Measurement Table configuration menu, double-tap anywhere in a Measurement Results table.
Measurement Table menu
Field or control Description
Column Visibility panel
Label Adds a Label column to show the user-defined label for all measurements. If no user-defined label
exists, the column shows the default measurement name.
Peak-to-Peak Adds a Peak-to-Peak column and shows a Pk-Pk readout for all relevant measurements.
Check boxes to select columns
to display
Select or clear individual statistic check boxes to add or remove that column from the table.
Column Resolution panel
Measurement column
resolution
Sets the resolution (number of digits to display) in each measurement column.
Set to Defaults Sets all columns to show 5 digit readout resolution.
Other panel
Statistics Sets the amount of statistical information you want to display for each measurement.
Both shows both the accumulated results and the current acquisition results.
All Acquisitions shows statistics for all acquisitions from the last action that cleared acquisition
memory
.
Current Acquisition shows the statistics for just the current acquisition.
Show Cycle-to-Cycle Variation For measurements where this applies, this function allows you to see the mean or average variation
between measurements performed on each available cycle in the waveform.
Row Height Optimized For Sets the row height of the Measurement results table as per your preference for Mouse or Touch.
Save Table Opens a menu with which to save the results table data to a file. See Save As configuration menu
(Measurement Results Table) on page 123.
Measurements Results Table operations
•
Double-tap anywhere on a results table to open its configuration menu.
Menus and dialog boxes
122
To Next Page
Loading...
