Menus and dialog boxes
All of the menus on your instrument and the available settings within each menu.
Act On Event configuration menu
Use this configuration menu to set the actions the instrument takes when specified conditions are met (trigger event, measurement limit
failure, mask hit failure, and so on).
To open the Act On Event menu, select the Act On Event button in menus where this button is available.
Act On Event menu fields and controls
Displayed fields and controls can change depending on menu selections.
Field or control Description
Actions To Take panel
Act on Event On/Off Allows you to configure Act On Event before enabling. If the maximum number of saves is hit, this
control turns of
f.
Event Type Select the event type as Discrete Events or Timer Events for saving screen capture, measurement
result statistics logging, and saving waveforms.
Note: The Timer events does not work with Single/sequence. It runs for Run/Stop
sequencing only.
Timer Interval Sets the time interval between two timer events. Available when Event T
ype is Timer Events.
Count Sets number of timer events that should happen before stopping Run/Stop sequencing. Available
when Event T
ype is Timer Events.
Table continued…
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 105
To Next Page
Loading...
