Setup and Hold Search configuration menu on page 158
T
imeout Search configuration menu on page 160
Bus Search configuration menus
Use a Bus search to search for and mark bus-related events (Start, Stop, Missing Acq, Address, Data, and so on) on a bus waveform.
To create a new Bus search:
1. Tap Search.
2. Set the Search Type to Bus.
3. Select the bus Source.
4. Use the search menu fields to set the search parameters.
To change the settings of an existing search, double-tap the search badge to open its configuration menu and make necessary changes.
Select a link to view the configuration menu settings for a specific bus.
CAN serial bus search configuration menu (when not using a .dbc symbol definition file) on page 143
I2C serial bus search configuration menu on page 140
LIN serial bus search configuration menu on page 148
NFC serial bus search configuration menu
Parallel bus search configuration menu on page 139
RS-232 serial bus search configuration menu on page 142
SENT serial bus search configuration menu on page 149
SPI serial bus search configuration menu on page 141
Other search types
Edge Search configuration menu on page 151
Logic search configuration menu on page 152
Pulse Width Search configuration menu on page 154
Rise/Fall Time Search configuration menu on page 156
Runt Search configuration menu on page 157
Setup and Hold Search configuration menu on page 158
Timeout Search configuration menu on page 160
Parallel bus search configuration menu
Use the Parallel Search configuration menu to define conditions to search for and mark on an Parallel bus waveform. You can have
multiple searches on the same bus.
Note: Parallel bus search is standard on all instruments.
Field or control Description
Display Enables or disables displaying search marks on this search.
Table continued…
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 139
To Next Page
Loading...
