Tektronix MSO 2 Series - Connect to a Network (LAN); Mount a Network Drive from a Standard Instrument

7. Use the probe adjustment tool provided with the probe to adjust the probe until the waveform has as flat a top and bottom as possible.
Remove the adjustment tool before looking at the waveform. Repeat until waveform top and bottom are flat. See your probe manual for
adjustment location and instructions.
8. Repeat these steps for each probe connected to each channel. Y
ou must run this procedure every time you move a probe from one
channel to another.
Connect to a network (LAN)
Connecting to a network allows you to remotely access the instrument.
Work with your network administrator to obtain the required information to connect to your network (IP address, Gateway IP address,
Subnet Mask, DNS IP address, and so on).
1. Connect a CAT5 cable from the instrument LAN connector to your network.
2. Select Utility > I/O on the menu bar to open the I/O configuration menu.
3. Obtain or enter the network address information:
• If your network is DHCP-enabled, and the IP address field does not already show an address, tap Auto to obtain the IP address
information from the network. DHCP mode is the default mode.
• If your network is not DHCP-enabled, or you need a permanent (non-changing) IP address for this instrument, tap Manual and
enter the IP address and other values provided by your IT or system administrator resource.
4. Tap Test Connection to verify that the network connection is working. The LAN Status icon turns green when the instrument
successfully connects to your network. If you have problems connecting to your network, contact your system administration resource
for help.
Mount a network drive from a standard instrument
Use this procedure to mount (map) a network Linux mount point shared directory on a standard (non Windows OS) instrument.
Prerequisites: The oscilloscope must be connected to a network that has access to the directories to mount or unmount. See Connect to
a network (LAN) on page 52.
To mount a Linux network drive on the oscilloscope, the network Linux mount point (drive, host) that you want to mount must be exported.
If the mount point is not exported, work with your organization's IT resource to get that location exported and accessible to your network.
To mount a network drive on your standard oscilloscope:
1. Tap File > File Utilities.
2. Tap Mount to open the Mount Drive menu.
3. Select Network in the Drive Type.
4. Select the drive letter to assign to the network drive from the Drive Letter list.
5. Tap Name or IP to specify how you will enter the host name (server) of the network mount location or PC.
Configure the instrument
52