Badge group characteristics
•
Badges in a group are listed left to right in the order they were added to the group.
• The badge group color is the color of the last selected badge in the group.
• Use standard touch and menu interactions to select and change individual badge settings.
• You can drag and move badge groups the same way as individual badges.
• The order of badges or badge groups (left to right) determines the order of slices in the display (top to bottom).
• To ungroup a single badge, drag it vertically and release. You can also ungroup a single badge by touching and holding a badge in the
group to open its right-click menu, and select Ungroup Badge(x) to ungroup the selected badge.
• To ungroup the entire group, touch and hold any badge in the group to open its right-click menu. Select to ungroup the selected badge
or ungroup all of the badges.
Badge group caveats
• You cannot drag badges within a group to change their order.
• You cannot add one badge group to another.
• You cannot drag a badge group onto an individual badge to group those badges.
Configuration menus
Configuration menus let you quickly set the parameters for channels, system settings (Horizontal, Trigger), measurements, cursor
readouts, Waveform and Plot views, callout text, and so on.
Double-tap an item (badge, Waveform View or Plot View, cursor readouts, callout text, and so on) to open its configuration menu. For
example, double-tap a Channel badge in the Settings Bar to open its configuration menu.
Selections or values that you enter take effect immediately. Menu contents are dynamic, and can change depending on your selections,
instrument options, or attached probes.
Related settings are grouped into 'panels'. T
ap the panel name to show those settings. Changes to panel settings can change the values
and/or fields shown in that panel and other panels.
Tap anywhere outside a configuration menu to close it.
Getting acquainted with your instrument
44
To Next Page
Loading...
