3. T
ap Save Location or Browse to select the location to save the file.
a. Tap the Save Location drop down arrow and select the location to save the file from a list of recent save locations. Or double-tap
the field and use the virtual keyboard to enter a path to the save location.
b. Tap Browse to open the Browse Save As Location configuration menu to navigate to and select a location at which to save the
file.
4. File Name shows the name last used to save a file. The default name is Tek000. To change the file name, double-tap the file name
and enter a new file name using the virtual keyboard.
5. Tap Auto Increment File Name to enable or disable automatic incrementing of a file name. Auto Increment File Name lets you save
sequential files without needing to manually rename them each time. The count number is added to the end of the file name.
• If Auto Increment File Name is enabled the Count defaults to 000 if there are no files at the specified location and file name
that already use incremented file names. If there are files at the save location that already use the specified file name, and have
already been saved using count increments, the Count field shows the next count value that will be added to the file name when
the file is saved.
• To change the starting count value, tap the Count field and use the assigned knob to change the value, or double-tap the field
and use the virtual keypad to change the value.
6. Tap Save As Type and select the report file format from the list.
7. Tap Append Report to enable appending this report to a previous report that uses the same file name.
8. Double-tap Comments and use the virtual keyboard to add descriptive comments to the report.
9. Tap Include Images and Annotations to include screen images and annotations in the report.
10. Tap Include Setup Configuration to include the instrument settings data in the report.
11. Tap Save to save the report file to the specified file name, location, and type.
Save sessions
Use this procedure to save a session file. A session file contains instrument setup information, measurements, reference waveforms of
active signals, plots, and eye diagram masks if enabled.
1. Tap the File menu and select Save As.
The Save As configuration menu opens.
2. Tap Session to open the Session tab.
3. Tap Save Location or Browse to select the location to save the file.
a. Tap the Save Location drop down arrow and select the location to save the file from a list of recent save locations. Or double-tap
the field and use the virtual keyboard to enter a path to the save location.
b. Tap Browse to open the Browse Save As Location configuration menu to navigate to and select a location at which to save the file.
4. File Name shows the name last used to save a file. The default name is Tek000. To change the file name, double-tap the file name and
enter a new file name using the virtual keyboard.
5. Tap Auto Increment File Name to enable or disable automatic incrementing of a file name. Auto Increment File Name lets you save
sequential files without needing to manually rename them each time. The count number is added to the end of the file name.
• If Auto Increment File Name is enabled the Count defaults to 000 if there are no files at the specified location and file name that
already use incremented file names. If there are files at the save location that already use the specified file name, and have already
been saved using count increments, the Count field shows the next count value that will be added to the file name when the file is
saved.
• To change the starting count value, tap the Count field and use the assigned knob to change the value, or double-tap the field and
use the virtual keypad to change the value.
6. Tap Save to save the session data to the specified file name, location, and type.
Saving and recalling information
102
To Next Page
Loading...
