Field or control Description
Polarity Sets the polarity of the pulse to detect (positive pulse only, negative pulse only, or a positive or
negative pulse).
Time Limit Sets the time period condition to be met.
A
vailable only when Mark When = < Limit, > Limit, = Limit, or != Limit.
Upper Threshold
Sets the upper amplitude level through which the signal must pass to be considered a valid transition.
Lower Threshold
Sets the lower amplitude level through which the signal must pass to be considered a valid transition.
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
Other search types
Bus Search configuration menus on page 139
Edge Search configuration menu on page 151
Logic search configuration menu on page
152
Pulse Width Search configuration menu on page 154
Rise/Fall Time Search configuration menu on page 156
Setup and Hold Search configuration menu on page 158
Timeout Search configuration menu on page 160
Setup and Hold Search configuration menu
Use the Setup and Hold search type to mark a waveform when a data signal changes state inside of a specified setup and hold time,
relative to a specified clock signal.
To create a new setup and hold search:
1. Tap Search.
2. Set the Search Type to Setup & Hold.
3. Select the search Clock Source.
4. Use the menu fields to set the search parameters.
To change the settings on an existing search, double-tap the search badge and make necessary changes.
Setup & Hold Search configuration menu fields and controls
Field or control Description
Display Sets the display of the mark icons to either On or Off. If you have multiple searches defined, the
control turns of
f just the marks for the selected search.
Act On Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page 105 for the available fields and controls.
Table continued…
Menus and dialog boxes
158
To Next Page
Loading...
