Bus Search configuration menus on page 139
LIN serial bus configuration menu on page 136
SENT serial bus search configuration menu
Use the SENT Search configuration menu to define conditions to search for and mark on an SENT bus waveform. Y
ou can have multiple
searches on the same bus.
Field or control Description
Display Enables or disables displaying search marks on this search.
Act on Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page
105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Search Type Set to Bus.
Source Select the SENT bus that you want to search.
Mark On Select the type of information for which to search.
Status / Communications Sets the value of the status/communications nibble for which to search.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Fast Channel.
Fast Channel 1 Sets the condition and value of the fast channel 1 data for which to search.
Tap the down arrow and select the condition for which to search (=, ≠, >, <, ≥, ≤). The default is =.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Fast Channel.
Fast Channel 2 Sets the condition and value of the fast channel 2 data for which to search.
Tap the down arrow and select the condition for which to search (=, ≠, >, <, ≥, ≤). The default is =.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Fast Channel.
High Value, Low Value Sets the high and low values of data for fast channel 1 and 2 for which to search.
Available when Mark On is Fast Channel and Fast Channel 1 or Fast Channel 2 is Inside Range or
Outside Range.
Counter Sets the condition and value of the counter data for which to search.
Tap the down arrow and select the condition for which to search (=, ≠, >, <, ≥, ≤). The default is =.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Fast Channel.
Table continued…
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 149
To Next Page
Loading...
