Field or control Description
Inverted Nibble Sets the value of the inverted nibble data for which to search.
T
ap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Fast Channel.
Message ID Sets the value of the message ID data for which to search.
Available when Mark On is Slow Channel.
Data Sets the condition and value of the slow channel data for which to search.
Tap the down arrow and select the condition for which to search (=, ≠, >, <, ≥, ≤). The default is =.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available when Mark On is Slow Channel.
Mark When Sets the mark when condition.
Tap the down arrow and select the condition for which to search (=, ≠, >, <, ≥, ≤, Inside Range,
Outside Range). The default is =.
When set to Inside Range or Outside Range, fields are displayed to set high and low boundary
values for the number of clock ticks for which to mark.
Available when Mark On is Pause Pulse.
Number of Ticks Sets the number of Pause Pulse ticks for which to search.
Tap the Ticks High or Tick Low field and use the A and B knobs to set the values.
Available when Mark On is Pause Pulse and Mark When is set to =, ≠, >, <, ≥, or ≤.
Ticks High, Ticks Low) Sets the highest and lowest values for the range of Pause Pulse ticks for which to search.
Tap the Ticks High or Tick Low field and use the A and B knobs to set the values.
Available when Mark On is Pause Pulse and Mark When is Inside Range or Outside Range.
Error Type Sets the error type for which to search. Tap the arrow and select the error condition.
Available when Mark On is Error.
CRC Type Sets the CRC error type for which to search.
Available when Mark On is Error and Error Type is CRC.
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
See also
Bus T
rigger configuration on page 220
Bus Search configuration menus on page 139
SENT serial bus configuration menu on page 137
Menus and dialog boxes
150
To Next Page
Loading...
