Tektronix MSO 2 Series - I2 C Serial Bus Search Configuration Menu

Field or control Description
Act on Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page
105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Search Type Set to Bus.
Source Select the parallel bus that you want to search.
Data Sets the data pattern for which to search. The number of bits shown depends on how the parallel bus
is defined.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
A, B knob controls Use the A knob to select (highlight) the digit(s) to change.
Use the B knob to change the value of the digit(s).
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
See also
Bus T
rigger configuration on page 220
Bus Search configuration menus on page 139
Parallel Bus configuration menu on page 127
I2C serial bus search configuration menu
Use the I2C Search configuration menu to define conditions to search for and mark on an I2C bus waveform. You can have multiple
searches on the same bus.
Field or control Description
Display Enables or disables displaying search marks on this search.
Act on Event Tap the Act on Event button to configure the actions the instrument must take when a search event
occurs. See Act On Event configuration menu on page
105 for the available fields and controls.
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is Off.
Search Type Set to Bus.
Source
Select the I
2
C bus that you want to search.
Mark On Select the type of information for which to search.
Direction Sets the transfer direction for which to search.
A
vailable when Mark On is Address or Address & Data.
Table continued…
Menus and dialog boxes
140