Field or control Description
Source Tap to select the source waveform from the drop-down list. Selected W
aveform automatically moves
the waveform cursors to the selected source or select a specific source from the drop-down list.
Available when Source Waveform is Same.
All is available in Source drop-down list only when the Cursor Type is set to Waveform.
All waveforms includes time domain based math waveforms, reference waveforms, trend waveforms,
etc.
Cursor A Source, Cursor B
Source
Tap to select the waveform sources for Cursor A and B.
Available when Source Waveform is Split.
Cursor A X-Position Tap to set a specific x-axis position for Cursor A using the multipurpose knob, or double-tap to set the
position using the keypad.
Cursor B X-Position Tap to set a specific x-axis position for Cursor B using the multipurpose knob, or double-tap to set the
X-Position using the keypad.
Cursor A Y-Position Tap to set a specific Y-axis position for Cursor A using the multipurpose knob, or double-tap to set the
position using the keypad.
Available when Cursor Type is H Bars or V&H Bars.
Cursor B Y-Position Tap to set a specific Y-axis position for Cursor B using the multipurpose knob, or double-tap to set the
X-Position using the keypad.
Available when Cursor Type is H Bars or V&H Bars.
Cursor Mode Tap to select the cursor mode.
Independent mode sets multipurpose knobs A and B to move each cursor separately.
Linked mode sets multipurpose knob A to move both cursors at the same time. Knob B will still move
cursor B independently of knob A.
Date and Time configuration menu
Use this menu to set the date, time format, and time zone.
T
o open the Date and Time configuration menu, double-tap on the Date/Time badge in the lower-right corner of the oscilloscope display.
Date and Time configuration menu fields and controls
Field or control Description
Display Tap to toggle display of the date and time On or Off.
When turned of
f, double-tap on the blank area below the Run/Stop button, in the lower-right corner of
the oscilloscope display, to open the configuration menu and set display to On.
Time Format Tap to select either 12 Hour or 24 Hour time format.
Time Zone Tap and select the desired time zone from the drop-down list.
Automatically adjust clock for
Daylight Saving Time
Sets the oscilloscope to automatically change the time to account for Daylight Saving Time changes.
Menus and dialog boxes
166
To Next Page
Loading...
