Pulse Width Search configuration menu on page 154
Rise/Fall T
ime Search configuration menu on page 156
Runt Search configuration menu on page 157
Setup and Hold Search configuration menu on page 158
Timeout Search configuration menu on page 160
Trigger configuration menu overview
Use the Trigger menu to define the channel or waveform signal conditions on which to trigger the oscilloscope. The trigger event
establishes the time-reference point in the waveform record. All waveform record data is located in time with respect to the trigger point.
To quickly change the trigger source from one channel to another, double-tap on the Trigger badge. Select the new trigger source from the
list. If you select a Digital channel, the list expands to show the individual digital channels. Single source trigger types include Edge, Pulse
Width, Timeout, Runt, and Rise/Fall Time.
To access the Trigger configuration menu, double-tap the Trigger badge on the Settings bar. The Trigger menu opens to show the settings
for the current trigger type.
Use the following links to see more information on specific trigger types and their configuration menus.
• Bus Trigger Menu
• Edge Trigger menu
• Logic Trigger
• Pulse Width Trigger menu
• Rise/Fall Time Trigger menu
• Runt Trigger menu
• Setup & Hold Trigger menu
• Timeout Trigger menu
Edge Trigger configuration menu
Use the edge Trigger menu to trigger the instrument when a signal rises and/or falls through a specified level.
To open the Edge trigger menu:
1. Double-tap the Trigger badge on the Settings bar.
2. Set the Trigger Type to Edge.
Settings panel (Edge Trigger configuration menu) fields and controls
Field or control Description
Trigger Type Set to Edge.
Table continued…
Menus and dialog boxes
212
To Next Page
Loading...
