Field or control Description
Copy Search Settings to
T
rigger
Sets the current oscilloscope trigger settings to match the search criteria.
Other search types
Bus Search configuration menus on page 139
Edge Search configuration menu on page 151
Pulse Width Search configuration menu on page 154
Rise/Fall T
ime Search configuration menu on page 156
Runt Search configuration menu on page 157
Setup and Hold Search configuration menu on page 158
Timeout Search configuration menu on page 160
Logic Search - Define Inputs configuration menu
Use the Define Inputs menu to select the logic condition to search on, and the logic threshold value, for each channel.
To open the Logic Search-Define Inputs configuration menu:
1. Double-tap a Logic Search badge on the Settings bar.
2. Tap the Logic Pattern > Define Inputs invoker button.
Logic Search - Define Inputs configuration menu fields and controls
Field or control Description
Ch(x) (analog channels) or D(x)
(digital Channels)
Use to select the signal sources logic condition on which to perform the logic search (High, Low, Don't
Care).
If a channel is a digital channel, tap the + symbol to open the list of digital inputs
(D15-D0) from which
to select individual logic conditions for the digital signals.
To set the threshold levels for digital channels, double-tap the digital Channel badge to open its
configuration menu.
Use the Threshold field to set the signal level that must be exceeded for that signal to be true (logical
1).
Set All Sets all signal sources to detect a logic High, Low, or Don't Care condition.
Pulse Width Search configuration menu
Use the Pulse Width search to mark a waveform whenever the specified pulse width condition occurs.
T
o create a new pulse width search:
1. Tap Search.
2. Set the Search Type to Pulse Width.
3. Select the search Source.
4. Use the menu fields to set the search parameters.
Menus and dialog boxes
154
To Next Page
Loading...
