Field or control Description
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity
, and search
results in a spreadsheet format. Default is off.
Stop Acquisition if Event
Found
Stops input acquisition when the search event occurs. Default is not enabled.
Search Type Set to Setup & Hold.
Clock Source Sets the signal to use as the clock. The clock source can be an analog, digital, math, or reference
waveform.
Clock Level Sets the threshold level that the clock signal must pass through to be considered a valid transition. The
clock threshold value is independent of the input signal threshold(s).
Clock Edge Sets the polarity of the clock edge (rising or falling) for evaluating the other menu conditions. The Logic
menu also lets you set the clock edge to either edge.
Data Sources Sets the data signal source(s). All selected sources must meet the specified setup and hold times. See
Setup and Hold Search - Define Inputs configuration menu on page 159.
Setup Time Sets the length of time that data signal should be stable and not change before a clock edge occurs.
Hold Time Sets the length of time that data signal should be stable and not change after a clock edge occurs.
Copy Trigger Settings to
Search
Sets the search criteria to match the current oscilloscope trigger settings.
Copy Search Settings to
Trigger
Sets the current oscilloscope trigger settings to match the search criteria.
Other search types
Bus Search configuration menus on page 139
Edge Search configuration menu on page 151
Logic search configuration menu on page
152
Pulse Width Search configuration menu on page 154
Rise/Fall Time Search configuration menu on page 156
Runt Search configuration menu on page 157
Timeout Search configuration menu on page 160
Setup and Hold Search - Define Inputs configuration menu
Use the Define Inputs menu to select the data signal source(s) and set their threshold level(s).
To open the Setup & Hold Search - Define Inputs menu:
1. Double-tap a Setup & Hold Search badge on the Results bar.
2. Tap the Data Sources > Define Inputs button.
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 159
To Next Page
Loading...
