Tektronix MSO 2 Series - Bus Trigger Configuration; CAN Serial Bus Trigger Settings Panel

Other trigger types
• Bus T
rigger Menu
• Edge Trigger menu
• Logic Trigger menu
• Pulse Width Trigger menu
• Runt Trigger menu
• Setup and Hold Trigger menu
• Timeout Trigger menu
Bus Trigger configuration
Use the Bus trigger menus to trigger on bus-related events (Start, Stop, Missing Ack, Address, Data, and so on).
Note: Y
ou must add a bus to the Waveform view before you can trigger on it. Add a math, reference, or bus
waveform on page 62.
To open the Bus trigger menu:
1. Double-tap the T
rigger badge on the Settings bar.
2. Set the Trigger Type to Bus.
3. Select the bus on which to trigger in the Source field.
Other trigger types
• Edge Trigger menu
• Logic Trigger
• Pulse Width Trigger menu
• Rise/Fall Time Trigger menu
• Runt Trigger menu
• Setup & Hold Trigger menu
• Timeout Trigger menu
CAN serial bus trigger settings panel
Field or control Description
Trigger Type Set to Bus
Source Select the CAN bus on which you want to trigger
.
Trigger On Select the type of information on which to trigger.
Available options are Start of Frame, Types of Frame, FD Bits, Identifiers, Data, Id & Data, XL Bits,
End of Frame, and Error.
Default is Start of Frame.
Start of Frame Sets the start of frame type for which to trigger.
End of Frame Sets the end of frame type for which to trigger.
Table continued…
Menus and dialog boxes
220