Field or control Description
Type of Frame Sets the frame type for which to trigger.
This trigger setting is available when CAN Standard is CAN XL or CAN 2.0 + FD (ISO) from the CAN
Bus configuration menu.
Frame Type Sets the frame type on which to trigger.
This trigger setting is available when T
rigger On is set to Type of Frame.
Direction Sets the transfer direction on which to trigger (Read, Write, Either).
This trigger setting is available when Trigger On is set to Identifier.
Identifier Format Sets the identifier for standard (11-bit) or extended (29-bit for CAN 2.0B) length.
This trigger setting is available when Trigger On is set to Identifier or ID & Data.
Identifier Sets the identifier pattern on which to trigger. The number of bits shown depends on the Identifier
Format setting.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
This trigger setting is available when Trigger On is set to Identifier or ID & Data for the Standard is
CAN XL or CAN 2.0 + FD (ISO) from the CAN Bus configuration menu. .
ID & Data Sets the ID & Data type for which to trigger.
This trigger setting is available when CAN Standard is CAN XL or CAN 2.0 + FD (ISO) from the CAN
Bus configuration menu.
Data Bytes Sets the number of data bytes on which to trigger (one to eight bytes). Use the A knob to change the
value.
This trigger setting is available when Trigger On is set to Data or ID & Data.
Data Sets the data pattern on which to trigger. The number of bits shown depends on the Data Bytes
setting.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
This trigger setting is available Trigger On is set to Data or ID & Data.
Data Offset Sets the byte offset value.
This trigger setting is available when Trigger On is set to Data or ID & Data.
Trigger When Sets the trigger when condition.
This trigger setting is available when Trigger On is set to Data or ID & Data.
XL Bits Sets the FD bits value on which to trigger.
This trigger setting is available when CAN Standard is in CAN 2.0 + FD (ISO) + XL or CAN 2.0 or
CAN FD (ISO) bus.
FD Bits Sets the FD bits value on which to trigger.
Available only when CAN Standard in CAN FD (ISO) bus.
Table continued…
Menus and dialog boxes
2 Series MSO MSO24 and MSO22 221
To Next Page
Loading...
