Battery pack information
The battery pack allows you to perform measurements without relying on AC power
. All 2 Series MSO instruments support the installation
of the battery pack.
You can operate the instrument continuously for approximately three hours with one battery and six hours with two batteries in the battery
pack. The instrument turns off automatically when the batteries run out of power. An on-screen icon and battery status menu indicates the
remaining battery power.
Parts list
Item Part Number Description
1 2-BP 2 Series MSO Battery Pack with two battery slots; ordered separate from instrument purchase.
2-BATPK 2 Series MSO Battery Pack with two battery slots; option ordered with instrument purchase.
2 TEKBAT-XX Battery; lithium-ion, rechargeable, SMBUS, recessed terminals, UL, safety controlled
3 211-1722-XX Pack of 4 screws, M4X.7X12MM
4 174-7369-XX Ground cable, safety controlled
Recommended installation tools
Use a screwdriver handle with No. 2 Phillips screw tip or a No. 2 Phillips screwdriver to install the battery pack onto your instrument.
Battery pack installation
Install the battery pack to the back of your instrument.
Before you begin
The battery pack must be empty during the installation procedure. After installation, insert one or two batteries into the battery pack before
you turn on the instrument.
CAUTION: The battery interface connector is susceptible to Electrostatic Discharge (ESD). Use ESD precautions with installing or
removing the battery pack.
WARNING: Before operating the instrument with the battery pack connected without an AC power source, always connect the
ground cable.
Installing your instrument
2 Series MSO MSO24 and MSO22 19
To Next Page
Loading...
