Button Description
Digital Adds or selects a digital waveform on the Waveform view. If no digital waveform exists, pushing the
button adds a digital waveform to the W
aveform view and opens the digital configuration menu. If only
one digital waveform is displayed, pushing the button turns off the digital waveform (removes it from
Waveform view). If two or more digital waveforms are displayed, pushing the button cycles through
selecting each digital waveform.
Autoset Automatically displays a stable waveform.
Default Setup Restores the oscilloscope settings (such as; horizontal, vertical, scale, position) to the factory default
settings.
Touch Off Turns touch screen capability off. The button is lighted when the touch screen is turned off.
Save Save is a one-push save operation that uses the current File > Save As settings to save screen-shots
(including open menus and dialog boxes), waveform files, instrument settings. If a File > Save or File
> Save As operation has occurred since the last instrument start-up, pushing the button saves the file
types to the location last set in the Save As configuration menu. If no file save operation has occurred
since the last instrument start-up, pushing the button opens the Save As configuration menu. Select
a tab to choose the type of file to save (such as; Screen Capture and Waveform), set any associated
parameters, and where to save it, and select OK. The specified file or files are saved. The next time
you push the button, the same type files are saved. Screen Captures save the entire screen, including
most displayed configuration menus and dialog boxes.
Rear and side panel connections
The rear and side panel connections supply power to the instrument and provide connectors for network, USB devices, digital probes,
battery pack, and instrument stand.
Getting acquainted with your instrument
30
To Next Page
Loading...
